Rainbow-electronics MAX3645 Uživatelský manuál Strana 3

  • Stažení
  • Přidat do mých příruček
  • Tisk
  • Strana
    / 10
  • Tabulka s obsahem
  • KNIHY
  • Hodnocené. / 5. Na základě hodnocení zákazníků
Zobrazit stránku 2
MAX3645
+2.97V to +5.5V, 125Mbps to 200Mbps Limiting
Amplifier with Loss-of-Signal Detector
_______________________________________________________________________________________ 3
Note 1: Between sensitivity and overload, the output amplitude is >95% of the fully limited amplitude and all AC specifications are met.
Note 2: Guaranteed by design and characterization.
Note 3: Noise is derived from BER measurement.
Note 4: The data input transition time is controlled by a 4th-order Bessel filter with f
-3dB
= 0.75 × data rate.
Note 5: PWD = [(width of wider pulse) - (width of narrower pulse)] / 2, measured with 155Mbps 0011 pattern.
Note 6: All LOS specifications are measured using a 155Mbps 2
23
- 1 PRBS pattern.
Note 7: The signal at the input is switched between two amplitudes, SIGNAL_ON and SIGNAL_OFF, as shown in Figure 1.
ELECTRICAL CHARACTERISTICS (continued)
(V
CC
= +2.97V to +5.5V, PECL outputs are terminated with 50 to V
CC
- 2V, R
TH
= 100, C
AZ
= 0.1µF, C
SD
= 1nF, T
A
= -40°C to
+85°C. Typical values are at V
CC
= +3.3V, T
A
= +25°C, unless otherwise noted.)
PARAMETER SYM B O L CONDITIONS MIN TYP MAX UNITS
TRANSFER CHARACTERISTICS
Bandwidth Gain = 60dB 150 250 MHz
C
AZ
= open 500
Low-Frequency Cutoff
C
AZ
= 0.1µF 0.5
kHz
LOSS-OF-SIGNAL SPECIFICATIONS (Notes 2, 4, 6)
LOS Sensitivity Range 0 R
TH
2k 220mV
P-P
LOS Hysteresis 10log (V
DEASSERT
/V
ASSERT
) 1.4 2 dB
LOS Assert/Deassert Time (Note 7) 2.3 80.0 µs
R
TH
= 0, low setting 0.5 0.9 1.3
R
TH
= 1k, medium setting 4.8 6.6 8.3LOS Assert Level
R
TH
= 2k, high setting 12 17 22
mV
P-P
R
TH
= 0, low setting 1.1 1.5 1.9
R
TH
= 1k, medium setting 8.0 10.8 13.5LOS Deassert Level
R
TH
= 2k, high setting 20 28 36
mV
P-P
Signal-Dectect Filter Resistance R
SD
Pin 7 14 20 26 k
Figure 1. Signal Levels for LOS Assert/Deassert Time
Measurement
TIME
V
IN
MAXIMUM DEASSERT LEVEL
1dB
6dB MAXIMUM POWER-DETECT WINDOW
SIGNAL ON
SIGNAL OFF
MINIMUM ASSERT LEVEL
0V
Zobrazit stránku 2
1 2 3 4 5 6 7 8 9 10

Komentáře k této Příručce

Žádné komentáře