MAX6901
then read the Seconds register again (final-seconds).
Check to see that final-seconds is equal to initial-sec-
onds. If not, repeat the write process. If the Seconds
register is to be written, update the Seconds register
first, and then read it back and store its value (initial-
seconds). Update the remaining timekeeping registers
and then read the Seconds register again (final-sec-
3-Wire Serial RTC in a TDFN
6 _______________________________________________________________________________________
Table 2. Register Address/Definition
defines power-on reset state of register content.
Komentáře k této Příručce