Rainbow-electronics DS1543 Uživatelský manuál stáhnout pdf (Strana 5)

DS1543

5 of 17

DS1543 REGISTER MAP Table 2

DATA

ADDRESS

FUNCTION/RANGE

1FFFh 10 Year YEAR YEAR 00-99

1FFEh X X X 10 M MONTH MONTH 01-12

1FFDh X X 10 Date DATE DATE 01-31

1FFCh X FT X X X DAY DAY 01-07

1FFBh X X 10 HOUR HOUR HOUR 00-23

1FFAh X 10 MINUTES MINUTES MINUTES 00-59

1FF9h

OSC

10 SECONDS SECONDS SECONDS 00-59

1FF8h W R Y Y Y Y Y Y CONTROL

1FF7h WDS BMB4 BMB3 BMB2 BMB1 BMB0 RB1 RB0 WATCHDOG

1FF6h AE Y ABE Y Y Y Y Y INTERRUPTS

1FF5h AM4 Y 10 DATE DATE ALARM DATE 01-31

1FF4h AM3 Y 10 HOURS HOURS ALARM HOURS 00-23

1FF3h AM2 10 MINUTES MINUTES ALARM MINUTES 00-59

1FF2h AM1 10 SECONDS SECONDS ALARM SECONDS 00-59

1FF1h Y Y Y Y Y Y Y Y UNUSED

1FF0h WF AF 0 BLF 0 0 0 0 FLAGS

X = Unused, read/writable under Write and Read AE = Alarm Flag Enable

bit control Y = Unused, read/writable without Write and

FT = Frequency Test bit bit control

OSC = Oscillator start/stop bit

ABE = Alarm in battery Back-up mode enable

W = Write bit AM1-AM4 = Alarm Mask bits

R = Read bit WF = Watchdog Flag

WDS = Watchdog Steering bit AF = Alarm Flag

BMB0-BMB4 = Watchdog Multiplier bits 0 = “0” and are read only

RB0-RB1 = Watchdog Resolution bits BLF = Battery Low Flag

CLOCK OSCILLATOR CONTROL

The Clock oscillator may be stopped at any time. To increase the shelf life of the backup lithium battery

source, the oscillator can be turned off to minimize current drain from the battery. The OSC bit is the

MSB of the seconds register (B7 of 1FF9h). Setting it to a 1 stops the oscillator, setting to a 0 starts the

oscillator. The DS1543 is shipped from Dallas Semiconductor with the clock oscillator turned off,

OSC

bit set to a 1.

READING THE CLOCK

When reading the RTC data, it is recommended to halt updates to the external set of double-buffered RTC

registers. This puts the external registers into a static state allowing data to be read without register

values changing during the read process. Normal updates to the internal registers continue while in this

state. External updates are halted when a 1 is written into the read bit, B6 of the Control register (1FF8h).

As long as a 1 remains in the Control register read bit, updating is halted. After a halt is issued, the

registers reflect the RTC count (day, date, and time) that was current at the moment the halt command

was issued. Normal updates to the external set of registers will resume within 1 second after the read bit

is set to a 0.

1 2 3 4 5 6 7 8 9 10 ... 16 17

Komentáře k této Příručce

Žádné komentáře

Rainbow-electronics DS1543 Uživatelský manuál Strana 5

Komentáře k této Příručce

Související produkty a manuály pro Počítačový hardware Rainbow-electronics DS1543