Rainbow-electronics MAX1039 Uživatelský manuál Strana 1

General DescriptionThe MAX1036–MAX1039 low-power, 8-bit, multichannel,analog-to-digital converters (ADCs) feature internaltrack/hold (T/H), voltage re

MAX1036–MAX1039Analog Input BandwidthThe MAX1036–MAX1039 feature input tracking circuitrywith a 2MHz small signal-bandwidth. The 2MHz inputbandwidth m

Single-Ended/Pseudo-Differential InputThe SGL/DIF bit of the configuration byte configures theMAX1036–MAX1039 analog input circuitry for single-ended

MAX1036–MAX1039SCL is high (Figure 5). A repeated START condition (Sr)can be used in place of a STOP condition to leave thebus active and in its curre

a START condition followed by 7 address bits and aread bit (R/W = 1). If the address byte is successfullyreceived, the MAX1036–MAX1039 (slave) issue a

MAX1036–MAX1039in random access memory (RAM). If the scan mode isset for multiple conversions, they all happen in succes-sion with each additional res

MAX1036–MAX10392.7V to 5.5V, Low-Power, 4-/12-Channel2-Wire Serial 8-Bit ADCs_________________________________________________________________________

MAX1036–MAX10392.7V to 5.5V, Low-Power, 4-/12-Channel2-Wire Serial 8-Bit ADCs16 ______________________________________________________________________

MAX1036–MAX10392.7V to 5.5V, Low-Power, 4-/12-Channel2-Wire Serial 8-Bit ADCs_________________________________________________________________________

MAX1036–MAX10392.7V to 5.5V, Low-Power, 4-/12-Channel2-Wire Serial 8-Bit ADCs18 ______________________________________________________________________

MAX1036–MAX10392.7V to 5.5V, Low-Power, 4-/12-Channel2-Wire Serial 8-Bit ADCs_________________________________________________________________________

MAX1036–MAX10392.7V to 5.5V, Low-Power, 4-/12-Channel2-Wire Serial 8-Bit ADCs2 _______________________________________________________________________

MAX1036–MAX10392.7V to 5.5V, Low-Power, 4-/12-Channel2-Wire Serial 8-Bit ADCs20 ______________________________________________________________________

In reality, there are other noise sources besides quanti-zation noise, including thermal noise, reference noise,clock jitter, etc. Therefore, SNR is c

MAX1036–MAX10392.7V to 5.5V, Low-Power, 4-/12-Channel2-Wire Serial 8-Bit ADCsMaxim cannot assume responsibility for use of any circuitry other than ci

MAX1036–MAX10392.7V to 5.5V, Low-Power, 4-/12-Channel2-Wire Serial 8-Bit ADCs_________________________________________________________________________

MAX1036–MAX10392.7V to 5.5V, Low-Power, 4-/12-Channel2-Wire Serial 8-Bit ADCs4 _______________________________________________________________________

MAX1036–MAX10392.7V to 5.5V, Low-Power, 4-/12-Channel2-Wire Serial 8-Bit ADCs_________________________________________________________________________

MAX1036–MAX10392.7V to 5.5V, Low-Power, 4-/12-Channel2-Wire Serial 8-Bit ADCs6 _______________________________________________________________________

MAX1036–MAX10392.7V to 5.5V, Low-Power, 4-/12-Channel2-Wire Serial 8-Bit ADCs_________________________________________________________________________

MAX1036–MAX1039Detailed DescriptionThe MAX1036–MAX1039 ADCs use successive-approximation conversion techniques and input T/H cir-cuitry to capture and

of the address byte (see the Slave Address section).The T/H circuitry enters hold mode two internal clockcycles later. A conversion or series of conve