Rainbow-electronics DS1904 Uživatelský manuál Strana 12

  • Stažení
  • Přidat do mých příruček
  • Tisk
  • Strana
    / 12
  • Tabulka s obsahem
  • KNIHY
  • Hodnocené. / 5. Na základě hodnocení zákazníků
Zobrazit stránku 11
DS1904
12 of 12
NOTES:
1. All voltages are referenced to ground.
2. V
PUP
= external pull-up voltage.
3. Input load is to ground.
4. Read data setup time refers to the time the host must pull the 1-Wire bus low to read a bit. Data is
guaranteed to be valid within 1 µs of this falling edge.
5. Under certain low voltage conditions V
IL1MAX
may have to be reduced to as much as 0.5V to always
guarantee a presence pulse.
6. The reset low time (t
RSTL
) should be restricted to a maximum of 960 µs, to allow interrupt signaling,
otherwise, it could mask or conceal interrupt pulses.
7. The master must read while the data is valid.
Zobrazit stránku 11
1 2 ... 7 8 9 10 11 12

Komentáře k této Příručce

Žádné komentáře