Rainbow-electronics AT83C24NDS Uživatelský manuál stáhnout pdf (Strana 6)

4234F–SCR–10/05

AT83C24

Operational Modes

TWI Bus Control The Atmel Two-wire Interface (TWI) interconnects components on a unique two-wire bus, made

up of one clock line and one data line with speeds of up to 400 Kbits per second, based on a

byte-oriented transfer format.

The TWI-bus interface can be used:

– To configure the AT83C24

– To select the operating mode of the card: 1.8V, 3V or 5V

– To configure the automatic activation sequence

– To start or stop sessions (activation and de-activation sequences)

– To initiate a warm reset

– To control the clock to the card in active mode

– To control the clock to the card in stand-by mode (stop LOW, stop HIGH or running)

– To enter or leave the card stand-by or power-down modes

– To select the interface (connection to the host I/O / C4/ C8)

– To request the status (card present or not, over-current and out of range supply

voltage occurrence)

– To drive and monitor the card contacts by software

– To accurately measure the ATR delay when automatic activation is used

TWI Commands

Frame Structure The structure of the TWI bus data frames is made of one or a series of write and read com-

mands completed by STOP.

Write commands to the AT83C24 have the structure:

ADDRESS BYTE + COMMAND BYTE + DATA BYTE(S)

Read commands to the AT83C24 have the structure:

ADDRESS BYTE + DATA BYTE(S)

The ADDRESS BYTE is sampled on A2/CK, A1/RST, A0/3V after each reset (hard/soft/general

call) but A2/CK, A1/RST, A0/3V can be used for transparent mode after the reset.

Figure 1. Data transfer on TWI bus

SDA

SCL

start condition

stop condition

1234

acknowledgement

from slave

Adresse byte

command

and/or data

1 2 3 4 5 6 7 8 9 10 11 ... 41 42

Žádné komentáře

Rainbow-electronics AT83C24NDS Uživatelský manuál Strana 6