Rainbow-electronics RF02 Uživatelský manuál stáhnout pdf

RF02

RF02 Universal ISM Band

FSK Transmitter

RF02

DESCRIPTION

Hope’s RF02 is a single chip, low power, multi-channel

FSK transmitter designed for use in applications requiring

FCC or ETSI conformance for unlicensed use in the 433, 868,

and 915 MHz bands. Used in conjunction with RF01, Hope’s

FSK receiver, the RF02 transmitter produces a flexible, low

cost, and highly integrated solution that does not require

production alignments. All required RF functions are

integrated. Only an external crystal and bypass filtering are

needed for operation. The RF02 offering a higher output

power and an improved phase noise characteristic.

The RF02 features a completely integrated PLL for easy

RF design, and its rapid settling time allows for fast frequency hopping, bypassing multipath fading and

interference to achieve robust wireless links. In addition, highly stable and accurate FSK modulation is

accomplished by direct closed-loop modulation with bit rates up to 115.2 kbps. The PLL’s high resolution

allows the use of multiple channels in any of the bands.

The integrated power amplifier of the transmitter has an open-collector differential output that directly

drive a loop antenna with programmable output level. No additional matching network is required. An

automatic antenna tuning circuit is built in to avoid costly trimming procedures and de-tuning due to the

“hand effect”.

For low-power applications, the device supports automatic activation from sleep mode. Active mode

can be initiated by several wake-up events (on-chip timer timeout, low supply voltage detection).

Tel: +86-755-86096587 Fax: +86-755-86096602 E-mail: [email protected] http://www.hoperf.com

1 2 3 4 5 6 ... 23 24

Shrnutí obsahu

Strany 1 - FSK Transmitter

RF02 RF02 Universal ISM Band FSK Transmitter RF02 DESCRIPTION Hope’s RF02 is a single chip, low po

Strany 2 - TYPICAL APPLICATIONS

RF02 Other Important Characteristics The antenna tuning characteristics was recorded in “max-hold”

Strany 3

RF02 Timing Diagram Control Commands Control Command Related Parameters/Functions 1

Strany 4 - PACKAGE PIN DEFINITIONS

RF02 d2 d1 d0 Clock Output Frequency [MHz] 0 0 0 1 0 0 1 1.25 0 1 0 1.66 0 1 1 2 1 0 0 2.5 1 0 1 3.

Strany 5 - Typical application

RF02 Oscillator control logic 3. Frequency Setting Command bit 15 14 13 12 11 10 9 8 7 6

Strany 6 - ELECTRICAL SPECIFICATION

RF02 5. Power Setting Command bit 7 6 5 4 3 2 1 0 POR 1 0 1 1 0 p2 p1

Strany 7 - AC Characteristic

RF02 after S periods of the microcontroller clock (if a1=1 and ex=0) to enable the microcontroller

Strany 8

RF02 Data Transmit Sequence Through the SDI Pin Note: Do not send CLK pulses with the TX data

Strany 9

RF02 Tel: +86-755-86096587 Fax: +86-755-86096602 E-mail: [email protected] http://www.hoperf.com

Strany 10 - CONTROL INTERFACE

RF02 Maximum XTAL Tolerances Including Temperature and Aging [ppm] Whenever a low frequency error

Strany 11 - Control Commands

RF02 Tel: +86-755-86096587 Fax: +86-755-86096602 E-mail: [email protected] http://www.hoperf.com

Strany 12

RF02 Tel: +86-755-86096587 Fax: +86-755-86096602 E-mail: [email protected] http://www.hoperf.com

Strany 13 - Oscillator control logic

RF02 REFERENCE DESIGNS Schematic PCB layout Top view Bottom view Tel: +86-755-86096587 F

Strany 14

RF02 SGS Reports Tel: +86-755-86096587 Fax: +86-755-86096602 E-mail: [email protected] http

Strany 15 - 1 1 0 0 0 1 1 0

RF02 Tel: +86-755-86096587 Fax: +86-755-86096602 E-mail: [email protected] http://www.hop

Strany 16 - [dbc/Hz]

RF02 RF02 BONDING DIAGRAM Pad Opening: 85um square, except 76um octagon pads (AN1, AN2)

Strany 17 - RX-TX ALIGNMENT PROCEDURES

RF02 Tel: +86-755-86096587 Fax: +86-755-86096602 E-mail: [email protected] http://www.hoperf.com

Strany 18

RF02 Tel: +86-755-86096587 Fax: +86-755-86096602 E-mail: [email protected] http://www.hoperf.com

Strany 19

RF02 up the microcontroller, effectively reducing the period the microcontroller has to be active.

Strany 20 - REFERENCE DESIGNS

RF02 9 MOD DI Connect to logic high 10 RFN AO Power amplifier output (open collector)

Strany 21 - SGS Reports

RF02 Tel: +86-755-86096587 Fax: +86-755-86096602 E-mail: [email protected] http://www.hoperf.com

Strany 22

RF02 Tel: +86-755-86096587 Fax: +86-755-86096602 E-mail: [email protected] http://www.hoperf.com

Strany 23 - RF02 BONDING DIAGRAM

RF02 Tel: +86-755-86096587 Fax: +86-755-86096602 E-mail: [email protected] http://www.hoperf.com

Strany 24

RF02 TYPICAL PERFORMANCE DATA (RF02) Phase noise measurements in the 868 MHz ISM band Unmodula

Komentáře k této Příručce

Žádné komentáře

Rainbow-electronics RF02 Uživatelský manuál

Procházejte online nebo si stáhněte Uživatelský manuál pro Bezdrátová sluchátka s mikrofonem Rainbow-electronics RF02. Rainbow Electronics RF02 User Manual Uživatelská příručka

Shrnutí obsahu

Komentáře k této Příručce

Související produkty a manuály pro Bezdrátová sluchátka s mikrofonem Rainbow-electronics RF02