Rainbow-electronics GM862-QUAD-PY Uživatelský manuál Strana 11
- Strana / 434
- Tabulka s obsahem
- KNIHY
Hodnocené. / 5. Na základě hodnocení zákazníků
AT Commands Reference Guide
80000ST10025a Rev. 5 - 09/07/08
Reproduction forbidden without Telit Communications S.p.A. written authorization - All Rights Reserved page 11 of 434
ATCMD1 CMD2=10+CMD1;+CMD2=, ,10;+CMD1?;+CMD1=?<CR>
anyway it is always preferable to separate into different command lines the basic commands and the
extended commands; furthermore it is suggested to avoid placing several action commands in the
same command line, because if one of them fails, then an error message is received but it is not
possible to argue which one of them has failed the execution.
If command V1 is enabled (verbose responses codes) and all commands in a command line has been
performed successfully, result code <CR><LF>OK<CR><LF> is sent from the TA to the TE, if
subparameter values of a command are not accepted by the TA or command itself is invalid, or
command cannot be performed for some reason, result code <CR><LF>ERROR<CR><LF> is sent
and no subsequent commands in the command line are processed.
If command V0 is enabled (numeric responses codes), and all commands in a command line has
been performed successfully, result code 0<CR> is sent from the TA to the TE, if sub-parameter
values of a command are not accepted by the TA or command itself is invalid, or command cannot be
performed for some reason, result code 4<CR> and no subsequent commands in the command line
are processed.
In case of errors depending on ME operation, ERROR (or 4) response may be replaced by +CME
ERROR: <err> or +CMS ERROR: <err>.
Note: The command line buffer accepts a maximum of 80 characters. If this number is exceeded none
of the commands will be executed and TA returns ERROR.
3.2.2.1 ME Error Result Code - +CME ERROR: <err>
This is NOT a command, it is the error response to +Cxxx GSM 07.07 commands.
Syntax: +CME ERROR: <err>
Parameter: <err> - error code can be either numeric or verbose (see +CMEE).The possible
values of <err> are reported in the table:
Numeric Format Verbose Format
General errors:
0 phone failure
1 No connection to phone
2 phone-adaptor link reserved
3 operation not allowed
4 operation not supported
5 PH-SIM PIN required
10 SIM not inserted
11 SIM PIN required
12 SIM PUK required
13 SIM failure
14 SIM busy
15 SIM wrong
16 incorrect password
- AT Commands Reference Guide 1
- SW Version 2
- 7.03.00 / 7.02.05 2
- Contents 3
- DISCLAIMER 5
- 1 INTRODUCTION 6
- 2 APPLICABLE DOCUMENTS 7
- 3 AT COMMANDS 8
- 3.2 AT Command Syntax 9
- 3.2.1 String Type Parameters 10
- 3.2.2 Command Lines 10
- Valid for SELINT 0,1 only 15
- (context activation + DNS 17
- 3.2.5 Command Issuing Timing 19
- 3.3 Storage 20
- Valid for #SELINT=2 only 22
- 3.5 AT Commands References 31
- 3.5.3.1.2 Soft Reset - Z 34
- 3.5.3.1.24 Speaker Mode - M 40
- 3.5.3.2.1 Command Echo - E 40
- 3.5.3.3 Call Control 50
- 3.5.3.3.2 Tone Dial - T 54
- 3.5.3.3.3 Pulse Dial - P 55
- 3.5.3.3.4 Answer - A 55
- 3.5.3.3.5 Disconnect - H 55
- 3.5.3.4 Modulation Control 56
- 3.5.3.5 Compression Control 57
- 3.5.3.6 Break Control 58
- 3.5.3.7 S Parameters 59
- 3.5.3.7.2 Ring Counter - S1 60
- 3.5.4.1 General 68
- 3.5.4.2 Call Control 71
- ATD03282131321; 112
- 3.5.4.4.3 Enter PIN - +CPIN 114
- #SHDN #CSURVUC +CREG $GPSWK 120
- #WAKE #CSURVB +COPS $GPSSAV 120
- #GPIO #CSURVF +CPAS $GPSCON 120
- #ADC +CFUN $GPSPRG 120
- 3.5.4.6 Voice Control 148
- 3.5.4.7 Commands For GPRS 150
- Scheme 178
- 3.5.6.1.2 Model ID - +FMM 233
- 3.5.6.3 Serial Port Control 236
- 3.5.7 Custom AT Commands 238
- - (G-L): User Defined Tones 247
- AT#PSAV 296
- 3.5.7.3.2 Socket Info - #SI 316
- 3.5.7.3.7 Socket Dial - #SD 321
- 3.5.7.4 FTP AT Commands 326
- 3.5.7.4.4 FTP Put - #FTPPUT 327
- 3.5.7.4.5 FTP Get - #FTPGET 328
- 3.5.7.5.8 Query DNS - #QDNS 341
- #CSURVUC 388
- #CSURVNLF 392
- Interpreter, AT Commands 409
- 3.5.7.10.8 Reboot - #REBOOT 417
- 4 List of acronyms 431
- 5 Document Change Log 433
Související produkty a manuály pro GPS přijímač Rainbow-electronics GM862-QUAD-PY
(2 stránky)© 2020, manymanuals.cz. Všechna práva vyhrazena. | 0.173 s |
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Komentáře k této Příručce