Rainbow-electronics Atmega169L Uživatelský manuál stáhnout pdf (Strana 190)

190

ATmega169V/L

2514A–AVR–08/02

Analog Comparator

Multiplexed Input

It is possible to select any of the ADC7..0 pins to replace the negative input to the Ana-

log Comparator. The ADC multiplexer is used to select this input, and consequently, the

ADC must be switched off to utilize this feature. If the Analog Comparator Multiplexer

Enable bit (ACME in ADCSRB) is set and the ADC is switched off (ADEN in ADCSRA is

zero), MUX2..0 in ADMUX select the input pin to replace the negative input to the Ana-

log Comparator, as shown in Table 86. If ACME is cleared or ADEN is set, AIN1 is

applied to the negative input to the Analog Comparator.

Digital Input Disable Register

0 – DIDR0

• Bit 1, 0 – AIN1D, AIN0D: AIN1, AIN0 Digital Input Disable

When this bit is written logic one, the digital input buffer on the AIN1/0 pin is disabled.

The corresponding PIN Register bit will always read as zero when this bit is set. When

an analog signal is applied to the AIN1/0 pin and the digital input from this pin is not

needed, this bit should be written logic one to reduce power consumption in the digital

input buffer.

Table 86. Analog Comparator Multiplexed Input

ACME ADEN MUX2..0 Analog Comparator Negative Input

0x xxxAIN1

11 xxxAIN1

1 0 000 ADC0

1 0 001 ADC1

1 0 010 ADC2

1 0 011 ADC3

1 0 100 ADC4

1 0 101 ADC5

1 0 110 ADC6

1 0 111 ADC7

Bit 76543210

– – – – – – AIN1D AIN0D DIDR0

Read/Write R RRRRRR/WR/W

InitialValue00000000

1 2 ... 185 186 187 188 189 190 191 192 193 194 195 ... 316 317

Žádné komentáře

Rainbow-electronics Atmega169L Uživatelský manuál Strana 190