Rainbow-electronics ATmega32L Uživatelský manuál stáhnout pdf (Strana 38)

ATmega32(L)

2503C–AVR–10/02

Watchdog Reset When the Watchdog times out, it will generate a short reset pulse of one CK cycle dura-

tion. On the falling edge of this pulse, the delay timer starts counting the Time-out period

TOUT

. Refer to page 39 for details on operation of the Watchdog Timer.

Figure 20. Watchdog Reset During Operation

MCU Control and Status

The MCU Control and Status Register provides information on which reset source

caused an MCU Reset.

• Bit 4 – JTRF: JTAG Reset Flag

This bit is set if a reset is being caused by a logic one in the JTAG Reset Register

selected by the JTAG instruction AVR_RESET. This bit is reset by a Power-on Reset, or

by writing a logic zero to the flag.

• Bit 3 – WDRF: Watchdog Reset Flag

This bit is set if a Watchdog Reset occurs. The bit is reset by a Power-on Reset, or by

writing a logic zero to the flag.

• Bit 2 – BORF: Brown-out Reset Flag

This bit is set if a Brown-out Reset occurs. The bit is reset by a Power-on Reset, or by

writing a logic zero to the flag.

• Bit 1 – EXTRF: External Reset Flag

This bit is set if an External Reset occurs. The bit is reset by a Power-on Reset, or by

writing a logic zero to the flag.

• Bit 0 – PORF: Power-on Reset Flag

This bit is set if a Power-on Reset occurs. The bit is reset only by writing a logic zero to

the flag.

To make use of the Reset Flags to identify a reset condition, the user should read and

then reset the MCUCSR as early as possible in the program. If the register is cleared

before another reset occurs, the source of the reset can be found by examining the reset

flags.

Bit 76543210

JTD ISC2 – JTRF WDRF BORF EXTRF PORF MCUCSR

Read/Write R/W R/W R R/W R/W R/W R/W R/W

Initial Value 0 0 0 See Bit Description

1 2 ... 33 34 35 36 37 38 39 40 41 42 43 ... 312 313

Žádné komentáře

Rainbow-electronics ATmega32L Uživatelský manuál Strana 38