Rainbow-electronics ATtiny10 Uživatelský manuál stáhnout pdf (Strana 98)

8127B–AVR–08/09

ATtiny4/5/9/10

14.3.2 Disabling

Provided that the NVM enable bit has been cleared, the TPI is automatically disabled if the

RESET

pin is released to inactive high state or, alternatively, if V

is no longer applied to the

RESET

pin.

If the NVM enable bit is not cleared a power down is required to exit TPI programming mode.

See NVMEN bit in “TPISR – Tiny Programming Interface Status Register” on page 106.

14.3.3 Frame Format

The TPI physical layer supports a fixed frame format. A frame consists of one character, eight

bits in length, and one start bit, a parity bit and two stop bits. Data is transferred with the least

significant bit first.

Figure 14-4. Serial frame format.

Symbols used in Figure 14-4:

ST: Start bit (always low)

D0-D7: Data bits (least significant bit sent first)

P: Parity bit (using even parity)

SP1: Stop bit 1 (always high)

SP2: Stop bit 2 (always high)

14.3.4 Parity Bit Calculation

The parity bit is always calculated using even parity. The value of the bit is calculated by doing

an exclusive-or of all the data bits, as follows:

P = D0

⊗ D1 ⊗ D2 ⊗ D3 ⊗ D4 ⊗ D5 ⊗ D6 ⊗ D7 ⊗ 0

where:

P: Parity bit using even parity

D0-D7: Data bits of the character

14.3.5 Supported Characters

The BREAK character is equal to a 12 bit long low level. It can be extended beyond a bit-length

of 12.

Figure 14-5. Supported characters.

TPIDATA

TPICLK

SP1ST SP2 IDLE/STIDLE PD1D0 D7

IDLE/STIDLE

BREAK CHARACTER

DATA CHARACTER

SP1ST SP2 IDLE/STIDLE PD1D0 D7

TPIDATA

1 2 ... 93 94 95 96 97 98 99 100 101 102 103 ... 165 166

Žádné komentáře

Rainbow-electronics ATtiny10 Uživatelský manuál Strana 98