Rainbow-electronics ATmega128L Uživatelský manuál stáhnout pdf (Strana 176)

176

ATmega128(L)

2467B–09/01

Receiving Frames with 9 Data

Bits

If 9 bit characters are used (UCSZ=7) the ninth bit must be read from the RXB8 bit in

UCSRB before reading the low bits from the UDR. This rule applies to the FE, DOR and

UPE status flags as well. Read status from UCSRA, then data from UDR. Reading the

UDR I/O location will change the state of the receive buffer FIFO and consequently the

TXB8, FE, DOR and UPE bits, which all are stored in the FIFO, will change.

The following code example shows a simple USART receive function that handles both

nine bit characters and the status bits.

Note: 1. The example code assumes that the part specific header file is included.

For I/O registers located in extended I/O map, “IN”, “OUT”, “SBIS”, “SBIC”, “CBI”, and

“SBI” instructions must be replaced with instructions that allow access to extended

I/O. Typically “LDS” and “STS” combined with “SBRS”, “SBRC”, “SBR”, and “CBR”.

Assembly Code Example

(1)

USART_Receive:

; Wait for data to be received

sbis UCSRA, RXC

rjmp USART_Receive

; Get status and 9th bit, then data from buffer

in r18, UCSRA

in r17, UCSRB

in r16, UDR

; If error, return -1

andi r18,(1<<FE)|(1<<DOR)|(1<<UPE)

breq USART_ReceiveNoError

ldi r17, HIGH(-1)

ldi r16, LOW(-1)

USART_ReceiveNoError:

; Filter the 9th bit, then return

lsr r17

andi r17, 0x01

ret

C Code Example

(1)

unsigned int USART_Receive( void )

{

unsigned char status, resh, resl;

/* Wait for data to be received */

while ( !(UCSRA & (1<<RXC)) )

;

/* Get status and 9th bit, then data */

/* from buffer */

status = UCSRA;

resh = UCSRB;

resl = UDR;

/* If error, return -1 */

if ( status & (1<<FE)|(1<<DOR)|(1<<UPE) )

return -1;

/* Filter the 9th bit, then return */

resh = (resh >> 1) & 0x01;

return ((resh << 8) | resl);

}

1 2 ... 171 172 173 174 175 176 177 178 179 180 181 ... 330 331

Komentáře k této Příručce

Žádné komentáře

Rainbow-electronics ATmega128L Uživatelský manuál Strana 176

Komentáře k této Příručce

Související produkty a manuály pro Senzory Rainbow-electronics ATmega128L