Rainbow-electronics ATmega128L Uživatelský manuál stáhnout pdf (Strana 50)

ATmega128(L)

2467B–09/01

Voltage Reference Enable

Signals and Start-up Time

The voltage reference has a start-up time that may influence the way it should be used.

The start-up time is given in

Table 20. To save power, the reference is not always turned

on. The reference is on during the following situations:

1. When the BOD is enabled (by programming the BODEN fuse).

2. When the bandgap reference is connected to the Analog Comparator (by setting

the ACBG bit in ACSR).

3. When the ADC is enabled.

Thus, when the BOD is not enabled, after setting the ACBG bit or enabling the ADC, the

user must always allow the reference to start up before the output from the Analog Com-

parator or ADC is used. To reduce power consumption in power down mode, the user

can avoid the three conditions above to ensure that the reference is turned off before

entering power down mode.

Note: 1. Values are guidelines only. Actual values are TBD.

Watchdog Timer The Watchdog Timer is clocked from a separate on-chip oscillator which runs at 1 Mhz.

This is the typical value at V

= 5V. See characterization data for typical values at other

levels. By controlling the Watchdog Timer prescaler, the Watchdog reset interval

can be adjusted as shown in

Table 22 on page 52. The WDR – Watchdog Reset –

instruction resets the Watchdog Timer. The Watchdog Timer is also reset when it is dis-

abled and when a chip reset occurs. Eight different clock cycle periods can be selected

to determine the reset period. If the reset period expires without another Watchdog

reset, the ATmega128 resets and executes from the Reset vector. For timing details on

the Watchdog reset, refer to

page 48.

To prevent unintentional disabling of the watchdog or unintentional change of time-out

period, 3 different safety levels are selected by the Fuses M103C and WDTON as

shown in Table 21. Safety level 0 corresponds to the setting in ATmega103. There is no

restriction on enabling the WDT in any of the safety levels. Refer to

“Timed Sequences

for Changing the Configuration of the Watch Dog Timer” on page 53

for details.

Table 20. Internal Voltage Reference Characteristics

(1)

Symbol Parameter Condition Min Typ Max Units

Bandgap reference voltage TBD TBD 1.23 TBD V

Bandgap reference start-up time TBD 40 70 µs

Bandgap reference current

consumption

TBD 10 TBD µA

1 2 ... 45 46 47 48 49 50 51 52 53 54 55 ... 330 331

Komentáře k této Příručce

Žádné komentáře

Rainbow-electronics ATmega128L Uživatelský manuál Strana 50

Komentáře k této Příručce

Související produkty a manuály pro Senzory Rainbow-electronics ATmega128L